Intermec 6820 Series, User Manual

Page: 93 / 184

Control Code Definitions
—
Chapter 5
77 6820 Series 80-Column Printer User’s Manual
Select Subscript Mode
All subsequent characters are printed approximately 2/3 the normal height
in the lower part of the character space, until
Cancel Subscript/Superscript is
encountered. Note that this function is not supported in DBCS.
Format
Decimal Hex ASCII
27 83 1* 1B 53 01* ESC “S” 1*
Cancel Subscript/Superscript Mode
The effects produced by Select Superscript Mode and Select Subscript Mode
are canceled. Factory default also disables both of these modes. Note that
this function is not supported in DBCS.
Format
Decimal Hex ASCII
27 84 1B 54 ESC “I”
Select Underline Mode
The underlining of all subsequent characters (including spaces) is enabled,
until the
Cancel Underline Mode function is encountered.
Format
Decimal Hex ASCII
27 45 1* 1B 2D 01* ESC “–” 1*
Cancel Underline Mode
The effect of the Select Underline Mode function is canceled. Factory de-
fault also disables the Underline mode.
Format
Decimal Hex ASCII
27 45 0* 1B 2D 00* ESC “–” 0*
Tabs and Tab Setting Functions
Horizontal Tabs
Horizontal tabs: set tabs, tab to next tab stop, clear tabs, set tab increments
S Tab settings are not affected by subsequent changes in pitch.
S Tabs may range up to maximum width for character and printer size.
S All previous tab stops are cleared when new tab stops are set. If the left
margin is changed after the horizontal tabs are set, tab stops are cleared.
S
Tabs become absolute positions and are not affected by any subsequent
change in character size.
S
All tabs set outside of the printable area are ignored.