Interalia SBX2, Installation & Operation Manual, Page: 78 / 89

CHAPTER 6 |
Remote Telephone Access
Remote Telephone Access Commands
Function Interactive Command Direct Command
Record Message 7#, then nnn# 7nnn#
Record Standby 7#, then 0# 70#
Play Message 8#, then nnn# 8nnn#
Replace Message 9#, then nnn# 9nnn#
Delete Message 39# then nnn# 39nnn#
Delete Messages in a List Node 51# then nnn# 51nnn#
Change System Access code 1#, then 0# (administrators only) 10# (administrators only)
Change Partition Access code using 1#, then nnn# (administrators only) 1nnn# (administrators only)
System Access code*
Change Partition Access code* 1# 1#
Change Message Access code** 1#, then nnn# 1nnn#
Obtain Line Counts 2#, then xy 2xy#
Switch Partition* - 0 nnn#
Obtain line counts for all lines on a 2#, then x, then 0 2x0#
card
Clear all line counts - 299#
Terminate Remote Access and Re- - 00#
start
Disconnect 0# 0#
Change Remote Access Language - 4z#
Change Partitions* - 0nnn#
Turns message on 31#, then nnn# 31nnn#
Turn message off 30#, then nnn# 30nnn#
Override Enabled - 591#
Override Disabled - 590#
Note : nnn = partition, message, or access code number
x = card number
y = line number
z = language number
* = only available with partitioning enabled
** = only available with partitioning disabled
+ = Message number
‘0’ is a temporary message (Standby Message), which can be recorded and played without affecting any other
messages. When the user decides that the temporary message is recorded properly, they can replace any message
Interalia | SBX
2
System Manual Page 72