3 Installing the Hardware and Software
3.2 Installing the Hardware
19
2.
Use a cable with 8P8C (RJ-45) connectors at both ends to connect the milling center to the computer, as
shown below.
0
.
3.2.2.
Connecting the Power
Safety
The milling center has an AC power cord terminated by a three-prong plug. The power cord
should be plugged into a three-hole, grounded receptacle. If a grounding adapter is used to
accommodate a two-prong receptacle, the adapter wire must be attached to a known
ground. Never remove the third prong from the plug on the AC power cord.
Follow the procedure below to connect the milling center to a power supply.
Procedure: Connecting the Power
1.
Ensure that the milling center’s power switch, located at its side, is set to the OFF position.
2.
Connect the power cord from the milling center to the power source.
0
.
3.2.3.
ProMill 8000 Installing Accessories
Each accessory kit is supplied with an installation guide.
Safety
To avoid stressing the milling center and creating a hazardous milling environment, use only
those accessories designed for use with the ProMill milling center, available through Intelitek
Corporation.
