Intel S2600IP, Technical Product Specification

Page: 86 / 186

Platform Management OverviewIntel® Server Board S2600IP and Intel® Workstation Board W2600CR TPS
72 Revision 1.1
Intel order number G34153-003
Event
Filter
Number
Offset Mask Events
1 Non-critical, critical and non-
recoverable Temperature sensor out of range
2 Non-critical, critical and non-
recoverable Voltage sensor out of range
3 Non-critical, critical and non-
recoverable Fan failure
4 General chassis intrusion Chassis intrusion (security violation)
5 Failure and predictive failure Power supply failure
6 Uncorrectable ECC BIOS
7 POST error BIOS: POST code error
8 FRB2 Watchdog Timer expiration for FRB2
9 Policy Correction Time Node Manager
10 Power down, power cycle, and reset Watchdog timer
11 OEM system boot event System restart (reboot)
12 Drive Failure, Predicted Failure Hot Swap Controller
Additionally, the BMC supports the following PEF actions:

Power off

Power cycle

Reset

OEM action

Alerts
The “Diagnostic interrupt” action is not supported.
4.5.3.14 LAN Alerting
The BMC supports sending embedded LAN alerts, called SNMP PET (Platform Event traps),
and SMTP email alerts.
The BMC supports a minimum of four LAN alert destinations.
4.5.3.14.1 SNMP Platform Event Traps (PETs)
This feature enables a target system to send SNMP traps to a designated IP address by means
of LAN. These alerts are formatted per the
Intelligent Platform Management Interface
Specification Second Generation v2.0 . A MIB file associated with the traps is provided with the
BMC firmware to facilitate interpretation of the traps by external software.
The format of the MIB file is covered under RFC 2578.
4.5.3.15 Alert Policy Table
Associated with each PEF entry is an alert policy that determines which IPMI channel the alert
is to be sent. There is a maximum of 20 alert policy entries. There are no pre-configured entries