Intel S1200BT, Service Manual, Page: 118 / 122

102 Intel® Server Board S1200BT Service Guide
•
Make sure the other adapter supports shared interrupts. Make sure your operating
system supports shared interrupts.
•
Try reseating the add-in adapter.
The add-in adapter stopped working without apparent cause
•
Try reseating the adapter first; then try a different slot if necessary.
•
The network driver files may be corrupt or deleted. Delete and then reinstall
the drivers.
•
Run the diagnostics.
System Boots when Installing PCI Card
System Server Management features require full-time “standby” power. This means some
parts of the system have power going to them whenever the power cord is plugged in,
even if you have turned the system power off with the power button on the front panel. If
you install a PCI card with the AC power cord plugged in, a signal may be sent to
command the system to boot. Before installing a PCI card, you should always:
•
Turn off the server power by using the power button on the front of the system.
•
Unplug the AC power cord(s) from the server.
Problems with Newly Installed Application Software
Problems that occur when you run new application software are usually related to the
software, not the server hardware. Faulty equipment is unlikely, especially if other
software runs correctly.
Check the following:
•
Make sure the system meets the minimum hardware requirements for the software.
See the software documentation.
•
Make sure the software is properly installed and configured for the system. See the
software documentation.
•
Use only an authorized copy. Unauthorized copies often do not work.
•
If you are running the software from a floppy disk, CD-ROM or DVD-ROM, try a
different disk.
•
Make sure the correct device drivers installed.
If the problems persist, contact the software vendor's customer service representative.