Intel® Server System R2600SR Setup and Service Guide
36
3.7
Replacing the Drive Carrier
Each compute node within the system is pre-populated with an SSD installed in a drive carrier. The single
SSD in its pre-populated drive bay is the only drive supported in this system.
3.7.1
Extracting the Drive Carrier
Figure 29. Extracting the drive carrier
To extract (remove) a drive carrier, complete the following steps:
1.
Pressing the button on the carrier face plate to release the locking lever.
2.
Using the lever, pull the carrier straight out and away from the drive bay.
3.7.2
Installing the Drive Carrier
Figure 30. Installing a drive carrier
To install a drive carrier, complete the following steps:
1.
Align the drive carrier with the open drive bay.
2.
With the locking lever in the open position, insert the drive carrier into the drive bay and push
forward until the drive makes contact with the backplane.
3.
Close the drive carrier locking lever until it locks into place to complete the installation.
Summary of Contents for R2600SR Series
Page 2: ...Blank page...
