Intel R2600SR Series, Setup And Service Manual

Page: 32 / 85

Intel® Server System R2600SR Setup and Service Guide
26
1. Align the air baffle latches with the baffle slots on both sides of the chassis.
2. Lower the air baffle straight down into the node. Press the air baffle down until it is securely seated
and the latches lock into place.
3.3 Replacing the CMOS Battery
The battery on the compute node powers the node ’s Real Time Clock (RTC) for up to 10 years in the absence
of power. When the battery starts to weaken, it loses voltage, and may lose stored server settings and system
clock and date settings.
Battery Specification:
 Lithium
 3V
 Coin type, CR2032
Contact your customer service representative or dealer for a list of approved devices.
Warning: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent
type recommended by the equipment manufacturer. Discard used batteries according to manufacturer’s
instructions.
Advarsel: Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med batteri af
samme fabrikat og type. Levér det brugte batteri tilbage til leverandøren.
Advarsel: Lithiumbatteri - Eksplosjonsfare. Ved utskifting benyttes kun batteri som anbefalt av
apparatfabrikanten. Brukt batteri returneres apparatleverandøren.
Varning: Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ som
rekommenderas av apparattillverkaren. Kassera använt batteri enligt fabrikantens instruktion.
Varoitus: Paristo voi räjähtää, jos se on virheellisesti asennettu. Vaihda paristo ainoastaan laitevalmistajan
suosittelemaan tyyppiin. Hävitä käytetty paristo valmistajan ohjeiden mukaisesti.
Figure 18. Removing the CMOS battery
To replace this battery, complete the following steps:
1. Remove the compute node to be serviced (see Section 0).
2. Remove the compute node cover (see Section 3.1.3).
3. Use a fingernail to press the top of the battery clip away from the battery. The battery pops up
when it is released.
4. Use thumb and index finger to lift the battery up and out of the socket.
Attention: Do not lift the battery by using excessive force. Failing to remove the battery properly may
damage the socket on the system board. Any damage to the socket may require replacing the system board.