Intel® Server System R2600SR Setup and Service Guide
35
3.6.2
Removing a DIMM
To remove a DIMM, complete the following steps:
1.
Open the locking latches at either end of the selected DIMM connector (see Letter A). The DIMM will
be unseated from the connector.
2.
Holding the DIMM by its edges, lift it up and away from the DIMM connector (see Letter B).
3.6.3
Installing a DIMM
Figure 28. Installing a DIMM
To install a replacement DIMM, complete the following steps:
1.
Locate the DIMM connector. Make sure the clips at either end of the DIMM connector(s) are pushed
outward to the open position (see Letter A).
2.
Holding the DIMM by the edges, remove it from its anti-static package.
3.
Position the DIMM above the connector.
4.
Align the notch on the bottom edge of the DIMM with the key in the DIMM connector (see Letter B).
5.
Insert the bottom edge of the DIMM into the connector (see Letter C).
6.
Once the DIMM is inserted, push down firmly and evenly on the top edge of the DIMM until the
retaining clips snap into place (see Letter D).
7.
Make sure the clips are firmly locked into place (see Letter E).
Summary of Contents for R2600SR Series
Page 2: ...Blank page...
