Intel M70KLP Series, Service Manual

Page: 78 / 109

Intel® Server System M70KLP Family Service Guide
76
Figure 98. Processor Carrier Clip Removal from PHM Assembly
3. Return the lever to the original position (see Letter C).
4. Detach the processor carrier clip from the heat sink.
• Unlatch the hook on each corner of the processor carrier clip and lift it from the heat sink
(see Letter D).
5.9.3 PHM Reassembly
To properly assemble the PHM and install it onto the server board, the procedures described in the following
sections must be followed in the order specified. These instructions assume that the processor heat sink
(New or reuse of existing) has the necessary Thermal Interface Material (TIM) (
DOWSIL™ TC -5888) already
applied.
Note: Full ESD precautions should be followed to perform reassembly of the PHM and reinstallation of the
PHM to the server board. At no time should the processor itself be handled.
Each component within the PHM assembly includes a Pin 1 indicator. Pin 1 indicator alignment between all
components is required throughout the assembly process.
Figure 99. Installing Processor Carrier Clip onto Processor – Part 1