Intel M70KLP Series, Service Manual

Page: 36 / 109

Intel® Server System M70KLP Family Service Guide
34
3.2.3 PCIe* Add-in Card Installation – Riser Cards
The following illustrations show the Riser 1 assembly. However, the instructions to add or remove an add-in
card is the same regardless of riser card assembly location.
Required Tools and Supplies
• Anti-static wrist strap and conductive workbench pad (recommended)
System Prerequisites
• The system must be powered off and AC Power cord(s) disconnected
1. Fold up the blue tab on the end of the riser assembly (see Letter A).
2. Rotate the blue tab counterclockwise ¼ turn to release the riser assembly from the server board
(see Letter B).
Note: To fully remove the riser assembly from the system, it may be necessary to first disconnect all auxiliary
PCIe cables (if present) from the back side of the riser card.
• Unlatch and pull the cable from the connector
Note : Remove the cable by grasping the plastic cable connector. Do not pull on the cable itself
Press down
to unlatch