Intel M70KLP Series, Service Manual

Page: 46 / 109

Intel® Server System M70KLP Family Service Guide
44
Figure 51. Memory Module Installation
2. Ensure that the ejection tabs at both ends of the memory slot are pushed outward to the open
position (see Letter A).
3. Carefully remove the memory module from its packaging, taking care to only handle it by its outer
edges.
4. Align the notch at the bottom edge of the memory module with the key in the memory slot
(see Letter B).
5. Insert the memory module into the memory slot.
• Using even pressure along the top edge, push down on the memory module (see Letter C) until
the ejection tabs of the memory slot snap into place (see Letter D).
6. Ensure that the ejection tabs are firmly in place (see Letter E).
Note: Intel® Optane ™ PMem devices require additional steps to enable and configure them. Refer to the
appropriate Intel® Optane™ PMem documentation to complete the installation process.
3.5 Network Adapter for OCP* 3.0 (Small Form Factor) – Installation / Removal
The system supports one (1) OCP 3.0 (Small for factor) add-in card. Supported OCP 3.0 cards have a pull-tab
to remove the card from the system and a thumbscrew to secure it to the system. Other OCP 3.0 small form
factor cards that use a latch or internal lock to secure and remove a card from the system are not supported.
An OCP 3.0 card is installed/extracted from an externally accessible OCP card bay on the system back panel
directly below the add-in slots for Riser 0.
Required Tools and Supplies
• Anti-static wrist strap and ESD safe workbench (recommended)
• Phillips* (cross head) screwdriver #1.
System Prerequisites
• The system must be powered off and AC Power cord(s) disconnected