Intel M70KLP Series, Service Manual, Page: 79 / 109

Intel® Server System M70KLP Family Service Guide
77
Figure 100. Installing Processor Carrier Clip onto Processor – Part 2
1. With the processor still in its tray, place the processor carrier clip over the processor.
2. Ensure the pin 1 indicator on the processor carrier clip is aligned with the pin 1 indicator of the
processor.
3. Gently press down simultaneously on two opposite sides of the processor carrier clip until it clicks in
place.
4. Repeat step 3 for the other two sides.
5. Locate the processor heat sink. To avoid damage, grasp it by its narrower sides as shown in Figure 101 .
Figure 101. Processor Heat Sink Handling
6. Place the heat sink bottom side up onto a flat surface.
If reusing an existing heat sink
• Properly clean off existing thermal interface material (TIM) from the bottom of the heat sink
• Apply new TIM (DOWSIL™ TC -5888)
If using a new heat sink
• Remove the plastic protective film (if present) from the Thermal Interface Material (TIM).