Operating Other Components Using Remote Controller
57
Using an Activities button with preset
operation
The following buttons have a preset operation as below.
Pressing the desired Activities button (My Movie, My TV or
My Music) will execute the operation.
My Movie
: The power of the TV, the player programmed to
BD/DVD, and the unit is turned on. The input is switched to
"BD/DVD" and playing starts.
r
Playing may not start depending on the start-up time
of the player. In that case, press
on the remote
controller.
My TV
: The power of the TV, the player programmed to
CBL/SAT, and the unit is turned on. The input is switched to
"CBL/SAT".
My Music
: The power of the player programmed to TV/CD
and the unit is turned on. The input is switched to "TV/CD"
and playing starts.
r
To use another Activities button after pressing an
Activities button, press All Off and then press the
desired Activities button.
To turn off all the devices programmed to the Activities
button
: Press All Off. The player, the unit and the TV
programmed to the Activities button you pressed before
pressing All Off will turn off (or enter standby).
r
If it is My Music that you pressed before pressing All Off,
the TV will turn off (or enter standby).
r
Some TVs may not turn off (or enter standby).
To change the player programmed to the Activities
button
: While holding down the Remote Mode button to
which you programmed the desired player, press and hold
the desired Activities button about 3 seconds. The change
is complete when the Activities button flashes twice.
To reset the Activities button
: While holding down Home,
press and hold All Off about 3 seconds until the All Off
button stays lit. Release Home and All Off and then press
All Off again. Reset is complete when the All Off button
flashes twice.
Assigning the desired operation to an
Activities button
You can assign an operation sequence to the desired
Activities button. For example, if you play the CD player
connected to the unit using the remote controller, the
following button operations are normally necessary.
1
Press Receiver to turn the remote controller into the
RECEIVER mode.
2
Press
Receiver to turn on the unit.
3
Press TV/CD to switch the unit's input to TV/CD.
4
Press
to start playing on the CD player.
If you assign these steps with the procedure below, you can
execute them by simply pressing a button. You can assign
up to 32 steps in one procedure.
1.
While holding down Receiver, press the desired
Activities button (My Movie, My TV or My Music) about 3
seconds until the Activities button (My Movie, My TV or
My Music) stays lit.
2.
Press the buttons to be used in order of their sequence.
Example: Playing CD
1
Press
Receiver.
2
Press TV/CD.
3
Press
.
3.
Press the Activities button (My Movie, My TV or My
Music) you pressed in step 1 again.
Assignment is complete when the Activities button
flashes twice.
r
After assignment of the Activities button is
completed, malfunction may occur if you overwrite
a button included in its operation sequence with any
other operation.
4.
To execute the learned operation, press and hold
Receiver and press the desired Activities button.
To clear the learned operation
:
1.
While holding down Home, press All Off about 3
seconds until the All Off button stays lit.
