Intec FORCE/2 HP, Instruction Manual

Page: 14 / 60

THE FORCE /2
Set-Up and Operation
12
ELECTRICAL CONNECTIONS:
Before connecting the machine to
electrical power, make sure all switches are in the "off " position. Connect
both supplied extension cords to dedicated 115V 20 amp grounded outlets. In
the home, refrigerator or freezer outlets usually fit the amperage requirements.
If necessary, these appliances can be temporarily unplugged, enabling the
FORCE/2 to use the outlet. Disconnecting
these appliances for the short time needed to
operate the FORCE/2 will not cause spoilage.
Remember to reconnect any unplugged
appliance after the job is finished. If your job
requires additional extension cords, make sure you use only a 10/3
cord for a 50 foot run or 8/3 cord for a 100 foot extension.
STARTING:
Operation from the Attic:
To use the remote control feature for attic
operation, the switches on the main electrical panel must be in the "on"
position. Control the machine using the rocker switch on the remote cord.
Operation from the Ground:
To operate the FORCE/2 from the
ground, the rocker switch on the remote control must be in the “on” position.
Operate the blower and agitator from the main electrical panel toggle
switches. Note: In cold weather, your machine is more difficult to start. If
possible, store your FORCE/2 in a warm area over-night before starting this
helps ensure the lubricant (oil) is warm,
enabling the bearings and gearbox to turn
freely.
S
E
T
-
U
P
A
N
D
O
P
E
R
A
T
I
O
N