Intec FORCE/2 HP, Instruction Manual

Page: 27 / 60

THE FORCE/2
Troubleshooting
Agitator does not Power cords Check cord
operate. not plugged in. and plug in.
Note:
Agitator can Loose power cord/ Check condition of
not be turned extension cord at electrical plug blades.
by hand. electrical connection.
Electricity not present at
Test extension cord with
Blower plug. Transformer known good appliance.
in machine not receiving If extension is not working
electricity. check house electrical or
circuit breaker at house.
Rocker switch for agitator Flip rocker switch
is not in “on” position. “on” at main panel.
Circuit breaker tripped on Push to reset tripped
main panel. circuit breaker.
Jam in airlock exit tube. Disconnect electrical power.
Remove hose from the
exit tube. Locate jam and
remove material with pliers.
See gearbox section for
additional info.
Jam between blade of Disconnect electrical power.
agitator and airlock. Remove insulation material
Note: Jam may not
from hopper. Locate jam
be visible
and remove material with
pliers. See gearbox section
for additional info.
Bearing on top of gearbox Have bearing replaced by
worn or frozen (bearing a qualified service center.
guides the agitator shaft).
Start-up capacitor blown
Have capacitor replaced by
on agitator motor. a qualified service center.
Remote rocker switch for Replace with original
agitator motor has failed. factory part.
Main panel rocker switch for Replace with original
agitator motor has failed. factory part.
Loose wire in electrical Have the system inspected
system. by a qualified service
center.
Agitator turns slow. Run capacitor in motor Have capacitor replaced
worn out. by a qualified service
center.
T
R
O
U
B
L
E
S
H
O
O
T
I
N
G
Problem Likely Cause Remedy
25