Page 15 of 24 Rev: 6/19/2013 10:26 AM
Dimming responders will begin to brighten, unless they are already at full-on.
Non-dimming responders will ignore the command and remain at their current state.
When you release the button, the responders will stop going brighter.
Once the scene is activated, pressing and holding the button will toggle between brightening and dimming the
responders. Non-dimmable responders will ignore press-and-hold brighten/dim commands and remain at their
current state.
LED Behavior
Keypad has a dual-color
green
and
red
LED which momentarily indicates if a button press was successfully
communicated to all scene members.
LED State
Meaning
Blinks green once
One or more scene members acknowledge the button press.
Blinks red once
One or more scene members did not acknowledge the button press (note:
scene members may still have heard the scene command and adjusted
their settings)
Local On-Level
The local on-level is the default brightness level at which the light(s) physically wired to Keypad will turn on. The
default local on-level is 100%, but can be set to any one of 33 settings, 32 fixed brightness levels (3% to 100%) or
“Resume Bright,” which will result in the light returning to the brightness level it was at prior to being turned off.
We recommend using home-management software such as HouseLinc to set the local on-level. However, you can
also change it manually by following the steps below.
1) Press and hold On and/or Off (or Main in 8-button configuration) until the connected light is at the brightness desired
when turned on locally (turn the light off if you wish to use the “Resume Bright” feature)
2) Tap the Set button
Keypad will beep
3) Test the Local On-Level settings by tapping the On/Off or Main buttons
Air Gap
To remove all power from Keypad and connected light(s), pull out the Set button at the bottom of the switch as far
as it will go, about 1/8”. (It might be helpful to use a small screwdriver.) This will open the mechanical contacts and
create an air gap.
To restore power, press the air gap back into place until its top is even with the trim frame.
Beep on Button Press
Default = Off
This setting is adjustable via software or a central controller only.
Error Blink
Default = on