![background image](http://html1.mh-extra.com/html/insteon/2334-232/2334-232_owners-manual_2069909014.webp)
Page 14 of 24 Rev: 6/19/2013 10:26 AM
Factory Reset
Factory Reset clears all user settings from Keypad including INSTEON scenes, on-levels, ramp rates, X10
addresses, etc.
1)
With a small screwdriver or your fingernail, pull out Set button to create an air gap.
2)
Wait 10 seconds.
3) Push in Set button hold. Do not let go.
Keypad will begin to emit a long beep.
4) When the beep stops, release the Set button.
Device’s embedded software will rewrite all settings to factory defaults.
A couple of seconds will pass.
Keypad will double-beep and its LEDs will return to normal brightness.
The connected load will turn on and Keypad will return to ready mode.
Adjust Local Settings
Each of the Keypad buttons is considered a “scene button,” meaning you can use any of the buttons on Keypad to
create
. Each button will control its own scene, only sending commands to devices linked
specifically to that button. Dimmable responders may behave differently, depending on whether you tap, double-tap
or press and hold a button to activate/deactivate a scene. Non-dimming responders will not respond to press-and-
hold brighten or dim commands; they will only turn full-on or full-off in response to taps and double-taps.
•
When the LED of the button is on, the scene has been activated (turned on).
•
When the LED of the button is off, the scene has been deactivated (turned off).
Activating/Deactivating scenes with the Keypad buttons:
•
Tap
to activate
Dimmable responders will turn on at their preset on-level at their programmed ramp rate.
Non-dimming responders will immediately turn full-on.
•
Tap
to deactivate
Dimmable responders will turn full-off at their programmed ramp rate.
Non-dimming responders will immediately turn full-off.
•
Double-Tap
to activate
Responders (both dimming and non-dimming) will immediately turn full-on.
•
Double-Tap
to deactivate
Responders (both dimming and non-dimming) will immediately turn full-off.
•
Press and hold
to activate