Page 13 of 24 Rev: 6/19/2013 10:26 AM
Turn Button Beep On or Off
The Keypad buttons can be set to Beep Mode so Keypad will beep every time a button is used. This feature is disabled
by default; to enable it, use home-management software such as HouseLinc or follow the steps below.
6-Button Configuration
1)
Simultaneously tap the B and C buttons
Keypad will beep
Keypad’s beeper will toggle to on (if it was off) or off (if it was on)
8-Button Configuration
1)
Simultaneously tap the D and E buttons
Keypad will beep
Keypad’s beeper will toggle to on (if it was off) or off (if it was on)
X10 Setup
Add X10 Address to a Button
1) Tap the Keypad scene button you want to add.
2) Press and hold Keypad’s Set button until it beeps.
Set button LED will blink green.
3) Send the desired X10 Address plus ON 3 times in a row
(e.g.
send B5-BON-B5-BON-B5-BON).
Keypad will double-beep and the Set button LED will stop blinking.
Remove X10 Address from a Button
If you are no longer going to utilize an X10 address associated with Keypad, it is very important that you remove its
X10 address. Otherwise, Keypad will still listen for X10 commands (somewhat hindering INSTEON reception) and
may respond to spurious X10 “noise” which is unavoidable. Furthermore, Keypad will transmit an X10 address and
command every time the button is pressed.
1) Tap the Keypad button.
2) Press and hold Keypad’s Set button until it beeps.
Set button LED will blink green.
3) Press and hold Keypad’s Set button again until it beeps again
The button’s LED will continue blinking red.
4) Send the X10 Address plus ON 3 times
(e.g.
send B5-BON-B5-BON-B5-BON).
Keypad will double-beep and the Set button LED will stop blinking.
Advanced X10 Programming
Instructions on setting X10 primary address and scene addresses can be found online:
http://www.smarthome.com/insteon-x10-programming.html
Power Restore
Keypad stores all of its scenes, properties, etc. in non-volatile memory. As such, all settings are retained after a power
outage. Upon power being restored, Keypad will return its connected load and all LEDs to their states prior to power
outage.