instagrid ONE max, User Manual

Page: 14 / 18

© 2022 instagrid All rights reserved
EN
14
5.3 Features
5.3.1 Starter battery
In addition to the actual energy storage system, the instagrid ONE max contains a starter
battery, to which the user need not usually pay attention. Nonetheless, in consideration
of subsection [9.1] , the underlying functionality of it will be explained in brief. The starter
battery is discharged when:
• The OFF operating state changes to CHARGE or DISCHARGE. The power required
for starting the internal control electronics is supplied by the starter battery.
• The instagrid ONE max is in the OFF operating state. The instagrid ONE max can
still be started after at least 6 months in the OFF operating state provided that the
starter battery was fully charged to begin with.
• The instagrid ONE max is in TRANSPORT mode. The instagrid ONE max can still
be started after at least 12 months in TRANSPORT mode provided that the starter
battery was fully charged to begin with.
The starter battery is charged when:
• The instagrid ONE max is in the
CHARGE or DISCHARGE operating
states. You can expect an empty
starter battery to be fully charged
after approx. 12 hours.
• The instagrid ONE max is in
TRANSPORT mode and the
charging inlet is connected to the
mains. You can expect an empty
starter battery to be fully charged
after approx. 5 hours.
6. WARNINGS AND FAULTS
Due to external or internal influences, conditions may arise when starting or operating the instagrid
ONE max that render the further use of the instagrid ONE max impossible; e.g. because of a defect
that is present, or because continued operation (without conditions being changed) could lead to
damage to the instagrid ONE max. If such a case occurs, the current operating state of the instagrid
ONE max is exited – inlet [8] and outlet [4 | 9] are deactivated, the LEDs [5] light up or flash yellow
or red.
Note: if a warning or fault message occurs when the instagrid ONE max is not in the CHARGE
operating state, the LED display goes out after 60 minutes. Otherwise, the displaying of the
message can be observed as long as the charging inlet [8] is connected to the mains.
6.1 Warning
Depending on the charge state of the instagrid
ONE max, one or more LEDs [5] light up
[section 6.1.1] or flash [section 6.1.2] yellow.
A warning is acknowledged by placing the
rotary switch [3] for at least 1 s in the

position and then in the

/

position
corresponding to the desired operating state.