instagrid ONE max, User Manual

Page: 13 / 18

© 2022 instagrid All rights reserved
EN
13
5.2.3 DISCHARGE
The instagrid ONE max is in the DISCHARGE state
when the rotary switch is in the

position and the
main storage unit still has sufficient power to maintain
operation of the instagrid ONE max in this state. In this
operating state, the following characteristics of the LED
display must be noted:
• If the LEDs go out after the start animation, the instagrid ONE max is fully
discharged and must first be charged; see [section 5.2.2] .
• In order to enable a precise indication of the charge state, the brightness of the
highest-value LED currently active gradually changes from bright to dark as
discharge progresses.
• This does not apply to the left LED. This lights up either with full brightness or
flashes.
• If the left LED is flashing, the charge state of the instagrid ONE max is low. When
combined with loads with a high power draw, in rare cases this may lead to a
compromise to operating behaviour. Charge the instagrid ONE max timely; see
[section 5.2.2] .
The main storage unit is connected to the outlet of the instagrid ONE max. Even with the
charging cable connected, the inlet and outlet are galvanically isolated; see [section 3.1] .
Use this operating state to supply a connected load with power. To do so, proceed as
follows:
• Make sure that the load is switched off and is not connected to the instagrid ONE
max.
• Set the instagrid ONE max to the DISCHARGE operating state.
• Connect the load to the outlet [4 | 9] of the instagrid ONE max.
5.2.4 TRANSPORT
The instagrid ONE max is in TRANSPORT mode when
the rotary switch is in the

position and all LEDs [5]
have gone out. There is no conductive electrical
connection between the inlet [8] , outlet [4 | 9] and the
internal electronics. As a special feature, in this state,
the internal energy storage system is completely inactive
and split into individual battery modules with an energy content of less than 100 Wh,
between which there is no conductive connection. In this mode, the starter battery
[section 5.3.1] can be charged by connecting the charging inlet to the mains. Always use
this operating state when you want to store [section 8.1] or transport [section 8.2] the
instagrid ONE max.