instagrid ONE max, User Manual

Page: 12 / 18

© 2022 instagrid All rights reserved
EN
12
• LEDs show pulsing animation in white: the internal control electronics are conducting a
start process with self-diagnostics functionality
• One or more LEDs light up or flash yellow: WARNING, see [section 6.1]
• One or more LEDs light up or flash red: FAULT, see [section 6.2]
• In the CHARGE [section 5.2.2] and DISCHARGE [section 5.2.3] operating states, the
current charge status of the instagrid ONE max is indicated through the number of LEDs
continuously lit up green
• Each LED segment corresponds to a charge of 12.5%
5.2 Operating states
5.2.1 OFF
The instagrid ONE max is in the OFF state when the
rotary switch is in the

position, the charging inlet is
not connected to the mains and all LEDs [5] have gone
out. In this state, the main storage unit is connected
neither to the charging inlet [8] nor the outlet [4 | 9] and
instead is in a standby mode, which is exited when the
charging inlet is connected to the mains. Use this operating state if you do not want to
supply a connected load with power for a short period of time.
5.2.2 CHARGE
The instagrid ONE max is in the
CHARGE state when the rotary switch
is in the

position and the charging
inlet is connected to the mains.
The LEDs display a green-coloured
progressive animation. In this state, the
main storage unit is connected to the charging inlet [8] , and the outlet [4 | 9] is voltage-
free. Use this operating state when you want to recharge the instagrid ONE max after
use, or to charge the instagrid ONE max prior to long-term storage; see [section 9.1] .
Note: the plug of the charging cable must first be connected to the instagrid ONE max
and then turned clockwise until it noticeably latches in.
Note: once all LEDs are continuously lit up green, the actual charging process ends,
but the cells undergo a balancing program for another approx. 60 minutes. It is
recommended that you disconnect the instagrid ONE max from the mains only once this
time has lapsed.
Note: it is possible to connect the instagrid ONE max to the mains via the charging inlet
provided the rotary switch [3] is still in the

position and to start the charging process
at a time of your choice by placing the rotary switch in the

position.