instagrid ONE max, User Manual

Page: 11 / 18

© 2022 instagrid All rights reserved
EN
11
• Check for completeness and damage.
• Place the rotary switch [3] in the centre position

.
• Connect the instagrid ONE max to the mains with the power cable. Wait until all the LEDs
[5] display green lights continuously.
Note: the plug of the charging cable must first be connected to the instagrid ONE max and
then turned clockwise until it noticeably latches in.
5. OPERATING STATES AND OPERATION
5.1 Concept of operation
By selecting one of the three possible positions

/

/

of the rotary switch [3] , the user
specifies the desired operating state. However, the actual operating state may differ from
this, for example, if the switch is in the

position, but the instagrid ONE max is completely
discharged. Use of the switch is described in detail in [section 5.2] .
The instagrid ONE max tells you the actual operating state through eight LEDs [7] . The LEDs
are also used to indicate warning and fault messages; see [section 6] . The following characteris-
tics must be noted:
• LEDs off: depending on the position of the rotary switch [3] , the following possibilities
arise.
Rotary
switch
Charging inlet [ 8 ] con -
nected to the mains
Meaning

- Device is in the operating state
TRANSPORT [section 5.2.4]

No Device is in the operating state
OFF [section 5.2.1]
Yes • Mains voltage not reaching the device.
Possible causes: power outage, charging
cable defective, input fuse [11] has
tripped; see [section 7.1]
• LED display possibly defective

- • Energy storage system completely
discharged
• A warning or fault has arisen during use
in the DISCHARGE operating state; see
[section 7]
• LED display possibly defective