The following is a recommended procedure for cantilever mounting. This
procedure requires a mounting kit (either ONT4KIT or ONT6KIT).
Figure 9: Digital Clock Cantilever Mounting
1.
Determine the clock mounting location.
2.
Using the template provided, mark the location where the clock is to be
mounted, making sure the center is located over the data cable outlet.
3.
Join the Ethernet Clock Mount and the Ethernet Clock Cantilever Wall
Mount using a #2 Phillips screwdriver and a
3
/
8
” wrench. Make sure that
the two washers are fitted between the Clock Mount and the Cantilever
Wall Mount. Refer to Figure 10.
Figure 10: Digital Clock Mounting Kits
4.
Insert 10 to 12 inches (30 cm) of data cable through the center hole of the
mounting unit.
5.
Attach the unit to the wall with fasteners suitable for the surface.
6.
Lift the clock into place and insert the data cable into the jack located on
the back of the clock.
7.
Position the keyhole slots located on the rear of the clock over the
mounting tabs on the clock mount.
8.
Pull the clock slightly downwards until the unit is seated securely.
9.
Repeat for the second clock if clocks are being installed back-to-back.
Summary of Contents for OnTime 4-Digit Digital Clocks
