EonNAS 3000 Series Hardware Manual
35
2.3.2
SAS Expansion Port
To connect JBODs, use the included SAS cable (SFF-8088 to SFF-8088) to connect
the expansion port on server in a sequence as shown below.
Each JBOD should be configured with a unique enclosure ID
using the rotary switch on its LED panel.
Use a small-size flathead screwdriver to change the ID.
NOTE
Setting an identical ID on two JBODs will cause ID conflicts. The enclosure ID
determines the WWN addresses for individual disk drives in each enclosure. For
detail JOBD enclosure connectivity support, please refer to your
system’Single SAS expansion out to single controller JBOD systems
CH0
CH1
CH2
CH3
SFF-8088
SAS-IN SAS-OUT
