InfiRay Outdoor
•
Tube TH35/TH50
•
Operating Manual www.infirayoutdoor.com
All rights reserved and shall not be copied and distributed in any form without written permission
Possible problems and solutions
Faults
Possible Causes
Solutions
The scope cannot be started
The battery is out of charge
Charge the battery
The device cannot be powered by an
external power supply
The USB cable is damaged
Replace the USB cable
The external power supply is insufficient
If necessary, check the external power supply
Images are fuzzy, not clear, not
balanced, with strings
Calibration is required
Calibrate the images as instructed in the manual
The Image is too dark.
The display brightness level is too low.
Adjust the display brightness
The GUI icons are clear but images are
blurry
The lens is not focused
Rotate the lens focus ring to adjust the focus
There is dust or condensate on the interior
or exterior optical surfaces of the lens.
Wipe off the outer optical surface by using a soft cotton cloth. Let
the riflescope dry by leaving it in a warm environment for 4 hours.
The position of the reticle moves after
shooting
The riflescope is not mounted securely or
the mount is not fixed on the riflescope.
Check that the riflescope has been securely mounted.
Make sure you are using the same type and caliber of the bullets as
when the riflescope and weapon were initially zeroed.
If your riflescope was zeroed in the summer and using in the winter
(or the other way round), a slight shift of the zero point is possible.
The scope cannot focus
Configuration error
Set the scope according to the
Power on and Image Setting
section.
Check the outer surface of the objective lens and eyepiece, and if
necessary, wipe off any dust and frost on it.
