InfiRay Outdoor
•
Tube TH35/TH50
•
Operating Manual www.infirayoutdoor.com
All rights reserved and shall not be copied and distributed in any form without written permission
bottom of the screen.
⚫
Press the rotary encoder
(7)
to switch the movement direction between the X axis and the Y
axis. The selected direction icon will become green.
⚫
Rotate the rotary encoder
(7)
to move the cursor along the direction selected, rotate clockwise
to move the cursor leftward or downward, and rotate anticlockwise to move the cursor
rightward or upward.
⚫
Repeat the preceding steps to change the cursor location until the cursor is aligned with the
defective pixel. Press the power button
(5)
briefly to add and calibrate the defective pixel and
the
Add
message will appear on the PIP window for a short time.
⚫
Repeat the above operations to remove other defective pixels.
⚫
At the same position, you can revoke the pixel defect calibration with a short press of the
power button
(5)
again.
Del
is displayed in PIP window.
⚫
Each time you add or delete a pixel defect, the number of pixel defects changes accordingly.
⚫
After calibration, press and hold the rotary encoder
(7)
until a prompt asking whether to save
appears on the screen.
⚫
Rotate the rotary encoder
(7)
to select Yes
or No to save or not.
⚫
Press the rotary encoder
(7)
to confirm the selection.
⚫
After Yes is selected, the countdown message "Saving...5" appears on the screen. It will exit
to the home screen after the prompt
Saving successful
appears.
