InfiRay Outdoor
•
Tube TH35/TH50
•
Operating Manual www.infirayoutdoor.com
All rights reserved and shall not be copied and distributed in any form without written permission
that proper (comfortable) holding of weapon ensures the distance
between the riflescope and eye (eye relief) specified by the
Technical
Specifications
. Failure to comply with this recommendation may
result in injury to the shooter by the parts of the riflescope eyepiece
when shooting.
⚫
It is recommended to install the riflescope as low as possible, at the
same time it should be away from the barrel or other devices.
⚫
Use the supplied torque wrench to tighten the screws of the mounting
rings but avoid pinching the riflescope body.
⚫
Before using the riflescope for hunting, please follow the instructions
in the
Zeroing
section to zero the device first.
⚫
It is recommended to use an eyecup while using the riflescope in the
dark in order to avoid detection of camouflage. Mounting the eyecup
on the riflescope eyepiece is carried out through the thread.
10
Operation
⚫
Open the lens cover
(14)
.
⚫
Press and hold the power button
(5)
for 2s to power on the device.
⚫
Rotate the lens focus ring
(13)
to focus on the object being observed.
⚫
Adjust the resolution of the icons on the display by rotating the diopter
adjustment ring
(2)
on the eyepiece.
⚫
Setting the image mode
: On the home screen, press the palette
button
(6)
to set the image palette mode: white hot, black hot, pseudo-
color, red hot, and highlight, in sequence. The icon on the top status
bar is updated in real-time.
⚫
Setting the display brightness
: On the home screen, press the
brightness button
(4)
to set the display brightness level from level 1 to
level 5. Meanwhile, a short prompt for the corresponding brightness
icon appears on the left side of the display.
⚫
Setting the image sharpness
: Press the rotary encoder
(7)
to go to
the shortcut menu, and set the image sharpness (refer to Chapter
"
Shortcut Menu
” for details).
⚫
Power off
: After using the
device, press and hold the
power button
(5)
for 3 seconds
to enter the power-off interface
with a shutdown countdown.
Release the button when the
countdown icon turns to 0, then
