Infinova V3060 Series, Installation & Operation Instructions

Page: 11 / 38

5
12 FOCUS Focus Control key Increase/Decrease focus in PTZ control
13 F1 F1 Function key The function is the same with F1 key in front panel
14 REC Video Record Function key
(1) Switch between preview interface and recording management
interface
(2) Call up presets in PTZ control, same as
Ǐ
PRST
ǐ
in front panel
15 PLAY Play Video Function key Same as
Ǐ
PLAY
ǐ
in front panel
16 ZOOM Zoom in/out Control key
Zoom in/out in PTZ control;
Note
: Zoom-
(1) Switch among tabs in submenu
(2) Hide/Display lower status bar in preview interface
17 PTZ PTZ Control key Same as
Ǐ
PTZ
ǐ
in front panel
18 PREV Multiple-screen Control key
(1) Switch multiple-screen(1,4,9,16 screens) display modes in preview
interface
(2) Clear all setting area in "Mask/Video mask alarm/Motion detection"
setting
19 Reserved
Remote controller installation and use method
1. Load battery
(1) Open the cover of the battery cabinet;
(2) Load 2 No.7 batteries, ensure the polarity is correct;
(3) Close the battery cabinet.
2. Start using remote controller
After the DVR has been started up well, press the DEV key on
the remote controller, then input the DVR's device number (the
default device No. is 1, it can be modified in "Display"), and then
press ENTER key. If the indicator on the controller turns green, it
means that the DVR is connected and can be controlled by remote
controller.
Note:
Device number should be 1 ~ 127.
3. Stop using remote controller
Press DEV key when the DVR is being controlled, the status
indicator will turn off, and then the remote controller stops to
control the DVR.
4. Shutdown DVR via remote controller
Press Switch key at least 3 seconds to turn off the DVR when it's
being controlled by controller.
In the preview mode a login box will pop up if password
protection is enabled. Users must select the user name and input a
correct password, and enter to "Shutdown" dialog box to select
"Confirm" to turn off the DVR.
Note:
Do not turn off the power switch in the rear panel before
the shutting indicator in front panel turns red.
In the menu mode, press the power switch key few seconds, there
will be the "shutdown" dialog box if the user has authority to
operate the "System Management", and then the user can select
"Confirm" to shutdown the DVR. If the user doesn't have the
authority on "System Management", the user can not turn off the
DVR normally.
5. Troubleshooting for remote controller
If the remote controller doesn't work normally:
y
Reduce the operating distance between DVR and controller
y
Aim the controller at the infrared receiver of the DVR
y
Check the polarity of the battery loaded
y
Change the used battery and load new battery
y
Check if the sensor of the controller is obstructed
y
Check if fluorescence lamp is being nearby
Note
: Please replace the controller if it still doesn't work after the
above operations. It should be the infrared receiver problem if the
new controller doesn't work either. Please contact after-sale
service engineer timely.