Hydrogen leak detector Sensistor ISH2000 HySpeed
-
Operating Instructions
OP-Sensistor ISH2000 HySpeed-EN-201203
7
EN
3
Controls and connections
The controls and connections are discussed and shown in this chapter.
Fig 3-1. Sensistor ISH2000 HySpeed controls and indicators.
3.1 Display
The display shows:
•
indicator bar in Detection Mode and the figures in Analysis Mode.
•
seven main menus. Their positions are indicated on a horizontal scale. Change from
one menu to another using the
<
and
>
buttons.
•
main menus have submenus, which are also indicated by horizontal scales and can
be selected using the
<
and
>
buttons.
•
scales for setting numeric values, languages, etc.
•
messages.
3.2 Push-buttons
The functions of the push-buttons are shown at the lower edge of the display. In this
manual the buttons are numbered, from left to right, 1, 2, 3, and 4. The push-buttons
are used to:
•
Change from one menu item to another using the
<
and
>
buttons.
•
Press
Enter
to move down to the nearest submenu.
•
Press
Save
to save the set value.
•
Press
Undo
to restore the previously set value.
•
Press
Esc
to move up to the nearest higher level(s).
3.3 LEDs
The two LEDs indicate the status of the instrument as follows:
•
Green flashing slowly, during warming up phase.
•
Green fixed light indicates that instrument is ready and hydrogen signal is below
Item
Description
1
Display
2
Loudspeaker
3
Control push-buttons
4
Earphone socket
5
Probe connector
6
LEDs
1
1
2
3 3 3 3
4
5
6