20
A toilet seat cover or toilet seat lid cover can
cause the occupied seat sensor to either remain
on continuously or not go on at all, leading to
faulty operation. In this event, remove the cover.
While this product is still new, there may be a
slight odor when using the drying function. As
the toilet is used, the odor will disappear.
To prevent the toilet seat and toilet seat lid
from slamming down, a damping mechanism is
provided to lower them gradually. If the toilet seat
or toilet seat lid is closed roughly or too forcefully,
this product could be damaged or fail.
Sit back fully on the toilet seat and arrange your
clothing so it does not get wet when using the
wash or bidet functions.
This product is constructed to use the tap water
pressure to extend the nozzles and spray water
from them. Where the tap water pressure is
extremely low, the nozzles may not spray water
at all with the spray strength at the weakest
setting. In this case, turn the STRENGTH dial
clockwise. (See page 23.)
• The capacity of the warm water tank is 0.88 L.
Water temperature gradually drops when the
wash or bidet is used. If the water drops below
a comfortable temperature, press the stop
button and wait about 3 minutes for the water to
reheat.
• The water temperature range is preset to the
following temperatures:
Low: Approx. 36 °C,
Medium: Approx. 38 °C,
High: Approx. 40 °C.
It takes approximately 10 minutes to heat
cold water (at about 5 °C) to the appropriate
temperature (about 38 °C).
Occupied seat sensor
This product is equipped with an occupied seat
sensor that prevents the water from spraying
and the dryer from operating if nobody is sitting
on the toilet seat. This prevents activation if the
wash, bidet, or dry button is pressed when the
toilet seat is unoccupied.
•
You are leaning forward or sitting on the front of
the seat.
Sit back fully on the toilet seat, or change the
way you sit on the toilet.
• You are wearing clothing that is black, napped,
or otherwise inhibits light reflection.
Cover the sensor with your hand or arrange
your clothing so that your skin is sensed by the
sensor.
• Dirt or water is on the sensor.
Remove the dirt or water from the sensor.
The occupied seat sensor uses light reflection
to function and may not operate in the following
cases:
This product may interfere with radio or
television reception. In this case, move the radio
or television away from this product until the
interference ceases.
Before and after washing and when the water
temperature adjustment button is pressed, etc.,
water is sprayed out around the nozzle, but this
is necessary due to this product's construction
and is not a sign of breakdown.
If water sprays under any other circumstances,
or sprays constantly, close the water shutoff
valve and remove the power plug from the
wall outlet. Then, contact the store where you
purchased this product.
Other references
GCW-1220-W-08110.indd 20
GCW-1220-W-08110.indd 20
2011/07/12 11:12:24
2011/07/12 11:12:24
Summary of Contents for CW-RS3-W
Page 1: ...GCW 1220 W 08110 4 indd 1 GCW 1220 W 08110 4 indd 1 2011 07 12 10 50 55 2011 07 12 10 50 55...
Page 2: ...GCW 1220 W 08110 4 indd 2 GCW 1220 W 08110 4 indd 2 2011 07 12 10 50 56 2011 07 12 10 50 56...
Page 3: ...GCW 1220 W 08110 4 indd 3 GCW 1220 W 08110 4 indd 3 2011 07 12 10 50 56 2011 07 12 10 50 56...
