38
Replacing batteries in the remote control
Remote Control Unit
Bracket
Back Cover
2. Remove the back cover and replace
the batteries with new ones (four 1.5V
AA alkaline batteries).
3. Replace the back cover, and set the
remote control unit back in its bracket.
1. Lift the remote control unit and
Remote remove it from its bracket.
Bracket
As the batteries weaken, the battery lamp will begin to blink.
* Usually, this battery lamp turns off.
* The batteries provided with this product have been used to check
operations during construction, and so may have a useful life
shorter than commercially available batteries.
* Depending on the size of the room, the wall finish and color
(particularly dark colors), the remote control unit may stop
functioning before the battery lampstarts blinking.
Replace the batteries with new ones using the following procedure.
Replacing batteries in the remote control
CAUTION:
Correctly install the batteries with the positive (+) and negative (-) terminals
facing the directions as shown on the remote control unit case.
Do not mix old and new batteries.
Only use alkaline batteries.
Battery lamp
GCW-1220-W-08110.indd 38
GCW-1220-W-08110.indd 38
2011/07/12 11:12:37
2011/07/12 11:12:37
Summary of Contents for CW-RS3-W
Page 1: ...GCW 1220 W 08110 4 indd 1 GCW 1220 W 08110 4 indd 1 2011 07 12 10 50 55 2011 07 12 10 50 55...
Page 2: ...GCW 1220 W 08110 4 indd 2 GCW 1220 W 08110 4 indd 2 2011 07 12 10 50 56 2011 07 12 10 50 56...
Page 3: ...GCW 1220 W 08110 4 indd 3 GCW 1220 W 08110 4 indd 3 2011 07 12 10 50 56 2011 07 12 10 50 56...
