14
5. Attachment of the water supply hose for the shower
toilet (at the branch fitting)
(1) Remove the
protective covers
from the ends of
the water supply
hose and insert
the hose into the
branch fitting.
Installation diagram
Water supply hose
for the shower toilet
CAUTION
•
Please be careful not to damage the O-ring.
* If the O-ring is damaged, it may cause water leaks.
•
Please firmly insert the clip.
* If the clip is not firmly inserted, it may cause water leaks.
•
Please insert the clip until you feel a click from the clip edge.
* If not firmly inserted, it may cause water leaks.
(2) Attach the clip in the same manner as
it is attached on the shower toilet, and
then attempt to twist the clip from side
to side to make sure that it is firmly
attached.
(1) Turn the water shutoff valve
counterclockwise to open the supply
of water to the tank and shower toilet.
(2) Operate the flush handle attached on
the tank and check each joint to see if
there are any water leaks.
* If water is leaking, further tighten the
connections, or re-install the shower toilet.
(3) Confirm that the water flow stops after
the tank is filled with water.
* If the tank does not fill with water, or the
water flow does not stop, please check
whether the ball tap and float ball are
functioning.
O-ring
Branch
fitting
Clip
6. Confirming water flow
O-ring
Branch fitting
Protective
covers
Water supply hose
Clip
Clip
Bend here
Branch fitting
Water shutoff valve
Turn counterclockwise.
Example of water supply from the floor
CAUTION
•
When water supply into the tank does not stop, or the
tank does not fill at all, please check if the float ball is
making contact with the inside wall of the tank.
•
If so, please reposition it using the following procedure:
(1) Loosen the inside nut on the side of the tank and
vertically straighten the ball tap.
(2) While holding the ball tap with your hand, tighten the nut.
•
Please do not remove the strainer while the water shutoff valve is open.
•
Doing so may cause water leaks from the strainer area.
Branch fitting area
Water supply socket area
• When removing the clip, hold
the clip with your fingers, set
the flathead screwdriver and
push the clip downward to
remove it as shown in the
figure below.
Flathead
screwdriver
GCW-1220-W-08110.indd 14
GCW-1220-W-08110.indd 14
2011/07/12 11:12:19
2011/07/12 11:12:19
Summary of Contents for CW-RS3-W
Page 1: ...GCW 1220 W 08110 4 indd 1 GCW 1220 W 08110 4 indd 1 2011 07 12 10 50 55 2011 07 12 10 50 55...
Page 2: ...GCW 1220 W 08110 4 indd 2 GCW 1220 W 08110 4 indd 2 2011 07 12 10 50 56 2011 07 12 10 50 56...
Page 3: ...GCW 1220 W 08110 4 indd 3 GCW 1220 W 08110 4 indd 3 2011 07 12 10 50 56 2011 07 12 10 50 56...
