In-situ Level TROLL 400, Operator'S Manual, Page: 50 / 85

1-800-446-7488 50 www.in-situ.com
Sensors Tab
The Sensors tab lists the sensors in the instrument, along with their serial numbers and calibration dates. Use the buttons in
this tab to calibrate and configure sensors.
Calibrate
Use the Calibration button to calibrate sensors or to adjust a level reference that is currently stored on the instrument. The
Calibrate button is not available when the instrument does not support calibration (e.g. BaroTROLL Instrument).
1. With the instrument connected to the software, select the Sensors tab.
2. Select the parameter you intend to calibrate.
3. Click the Calibrate button .
Configure
Use the Configure button to select parameter units and to configure parameters that support configuration. Examples
include Level/Depth, Specific Conductivity, and Total Dissolved Solids. Parameters cannot be configured while the
instrument is showing live data on the
Home screen or while the instrument contains an active log.
1. With the instrument connected to the software, select the Sensors tab.
2. Select the parameter you intend to configure.
3. Click the Configure button .
When you configure the Level parameter using the
Sensors
tab, the settings are stored in
the instrument and are available for use in Modbus, SDI-12, or analog communication (if
available). If desired, a different configuration can be selected when setting up a log.
Device Setup Tab
In general, you should not use the Device Setup tab unless you are corresponding with the In-Situ technical support team.
However, you can use this screen to set up communication protocols if you are connecting the instrument to a PLC or data
logger.