22
MIG CARPRO 1 / 3 / 3 DV
EN
Translation of the original instructions
Reel :
- Open the hood (1)
- Remove the reel holding nut (2) (NB. : no reversed screw)
- Tighten the locknut (3) to bulge the reel axis (do not tighten too much)
- Insert the reel-To insert the wire in the rollers, apply pressure on the «roller tension setting screw »
Torch:
- Pull out the wire of the torch 1 in winding up the reel.
- Pull out the torch 1.
- Plug the power connector of the spool on gun on the connector.
- Plug the control connector of the spool gun-Place the switch on position 1.
ADVICE AND THERMAL PROTECTION
- Respect the basic rules of welding.
- Leave the air holes of the device open to allow air circulation.
- Leave the device plugged after welding to allow its cooling.
- Thermal protection: The light (fig V-6) turns on and the cooling duration is a couple of minute according to the area
temperature.
SYMPTOMS
POSSIBLE REASONS
SOLUTIONS
The welding wire speed is not constant.
Cracklings blocking up the opening.
Clean out the contact batch or change it
and replace the anti-adherence product.
The wire skids in the rollers.
Control the roller pressure or replace it.
Wire diameter non-consistent with roller
Covering wire guide in the torch not
consistent with wire.
The unwinding motor doesn’t operate.
Reel or roller brake too tight.
Release the brake and rollers.
Electrical supply problem.
Check that the running button is on the
position on.
Bad wire unwinding.
Covering wire guide dirty or damaged.
Clean or replace
Reel brake too tight
Release the brake
No welding current
Bad connection to the mains supply.
Check the branch connection and ensure
it is fed by 3 phases.
Bad earth connection.
Control the earth cable (connection and
clamp condition).
Power contactor inoperative.
Control the torch trigger.
The WIRE rubs down after the rollers.
Covering WIRE guide crushed.
Check the covering and torch body.
Locking of the wire in the torch
Clean or replace.
No capillary tube.
Check the presence of capillary tube.
Wire speed too fast
Reduce the wire speed
