23
MIG CARPRO 1 / 3 / 3 DV
EN
Translation of the original instructions
The weld bead is porous.
The gas flow is not sufficient.
Adjusting range 15 to 20 L / min. Clean
the working metal.
Gas bottle empty.
Replace it.
Gas quality non-satisfying.
Replace it.
Air flow or wind influence.
Avert air blast, protect welding area.
Gas nozzle too full.
Clean or replace the gas nozzle.
Bad wire quality.
Use adapted WIRE for MIG-MAG welding.
Surface to weld in bad condition. (rust,
etc…)
Clean the working parts before welding.
Very significant flashing particules.
Arc voltage too low or too high.
See welding settings.
Bad earth connection.
Check and place the earth cable to have a
better connection.
Protecting gas insufficient.
Adjust the gas flow.
No gas at the torch output.
Bad gas connection.
See if the gas coupling beside the engine
is well connected.
The Spool on Gun does not work.
Connection problem
Check the torch connections (power and
control connectors).
In Spool on Gun mode, the speed adjus-
tement knob on the machine does not
work.
Normal condition of the machine.
When Spool on Gun is used, only the wire
speed knob on the torch is working.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
