T e c h n o l o g y f o r T h e W e l d e r ’ s W o r l d .
www.binzel-abicor.com
ABIcor BInZel corporation
650 Medimmune court, suite 110
frederick, Md 21703
Phone: (301) 846-4196
fax: (301) 846-4497
ABIROB W Liner Instructions
SI4-XXX Series Liners
LINCOLN DIRECT TORCHES
1. Position the torch cable as straight as possible.
2. With the torch neck and consumables fitted, insert the liner into the rear of the torch until it bottoms in the tip
holder/tip or wire-brake if fitted.
3. At the rear end of the torch measure the distance from the feeder plug to the end of the liner collet (Fig. 1). This is
dimension “X”.
4. Remove the liner from the torch and remove the dimension “X” from the front end of the liner (Fig. 2).
5. At the rear end of the liner, you must trim the excess liner which protrudes from the liner collet. Measure 4mm
past the collet and cut the excess off (Fig. 3). Note: When cut properly the liner should be flush to 1mm recessed in
the liner nut.
6. Apply O-ring grease. Install the liner into the torch and tighten the liner retention nut (Fig. 4).
Fig. 1
Fig. 2
Fig. 3
Fig. 4
liner
liner collet
X
4mm
liner retention nut
X
cut
INT.9034
ABIROB
W
Liner
Instructions
- Lincoln
• 04-14
©
2014
Alexander
Binzel
Corporation
• Printed
in
USA
Feeder plug
(Miller Direct Torches
on back...)
