Imperx Tiger T2040, User Manual

Page: 76 / 86

Tiger CCD Cameras with Camera Link
– User Manual
November 27, 2017 Page
76
of
86
Rev 1.0
Temp. Register Value
+127.75 °C 01 1111 1111
+0.25 °C 00 0000 0001
0° C 00 0000 0000
-0.25 °C 11 1111 1111
-128 °C 10 000 0000
Miscellaneous
Address Register Name Data Type Description
0x6000 Power Reset Data 00000001 WO Resets the CCD power after ESD
event
0x601C SW_Reset Data 0xDEADBEEF WO Command initiates software reset
(loads workspace from config
spaces set by Boot From data). You
must write data 0xDEADBEEF to
initiate reset.
0x0604 BAUD Rate
Selector Data (2:0) 0x0 – 9600
0x1 – 19200
0x2 – 38400
0x3 – 57600
0x4 – 115200 (default)
0x5 to 0x7 - reserved
Data (31:3) N/A
RW Sets communication baud rate
between camera and computer.
EOS Lens Control Information Registers
(T6640 ruggedized version only)
Address Register Name Data Type Description
0x6200 IRIS Step Value Data (7:0) <IRIS Step>
Data (31:8) N/A
RW Sets the IRIS step increment value.
0x6204 IRIS Close Step WO Closes IRIS one step per command.
The step value is set above 0x6200.
0x6208 IRIS Open Step WO Opens IRIS one step per command.
The step value is set above 0x6200.
0x620C IRIS Close Full WO Command fully closes the IRIS.
0x6210 IRIS Open Full WO Command fully opens the IRIS.
0x6214 IRIS Stop WO Command stops IRIS movement.
0x6218 FOCUS Step Value Data (7:0) <FOCUS Step>
Data (31:8) N/A
WR Sets FOCUS step increment value.
0x621C FOCUS Close Step WO Closes FOCUS one step per
command. The step value is set
above 0x6218.
0x6220 FOCUS Open Step WO Opens FOCUS one step per
command. The step value is set
above 0x6218.
0x6224 FOCUS Near Full WO Command sets FOCUS to full near
position.
0x6228 FOCUS Far Full WO Command sets FOCUS to full far
position.