19
Channels
This studio flash has a 16-channel radio receiver, which can be triggered using
the kit-included transmitter. To adjust the channel settings on the remote, first
remove the battery compartment door. Set the device to your required channel
using the chart below as a guide.
NOTE: You must synchronize the channel setting on the monolight and the trigger
to wirelessly trigger the flash.
Groups
The Impact Digital Monolight has four groups, used to segment remote devices.
To change the group the trigger is transmitting to, press the group selector
button until the required group selection corresponds with the correct indicator
light.
NOTE: You must synchronize the group setting on the monolight and the trigger
to wirelessly trigger the flash.
Replacing the Battery (CR2032)
To install a battery into the wireless trigger, first remove the battery compartment
door. Remove the spent battery from the battery holder by holding back the
battery securing clasp and pulling the battery out. Insert the new battery under
the battery securing clasp, using the correct orientation, and snap the other side
into place. Reinstall the battery compartment door to complete the process.
