13
Setting the Monolight’s Power Output
The Impact Digital Monolight’s flashtube has a 6-stop
power range, represented by a 1-6 (f-stop) numbered
scale on the LED screen. The output adjustment knob
changes the monolight output value by 0.1 f-stop.
NOTE:
Each detent of the output adjustment dial
changes the power output by one-tenth of a unit.
To increase or decrease the power output of the
monolight, turn the adjustment dial on the back of
the flash unit. This will adjust both the monolight
and modeling lamp (unless the modeling lamp is set
to independent mode on or off). For information on
adjusting the modeling lamp power output, refer to
page 14.
When stepping down the power of the flash, the
FLASH icon on the LCD screen will blink until the
capacitors release the accumulated energy (auto
power dump).
Flash Settings
Setting
Power
6.0
Full Power
5.0
1/2 Power
4.0
1/4 Power
3.0
1/8 Power
2.0
1/16 Power
1.0
1/32 Power
