6
PLACE
the base down on the table top and
line up the holes in the left top support arm with the
recessed nuts in the table top. If your desktop is 48” wide
you can proceed to Step 6.
IF YOUR
desktop is longer than 48” then the next step
is to adjust the crossbar width so that the holes in the
right top support arm also line up with the recessed
nuts in the table top.
BEFORE ADJUSTING the base width, mark the one
exposed center hole on each crossbar and ensure that
they stay centered as you adjust the width.
TO ADJUST
the crossbar width, loosen (do not remove)
the two set screws on either side of the center holes of
the crossbars, using the #5 Allen key. Slide the legs apart
to reveal the correct number of holes for your table top
size, keeping the unpainted “C channel” tube centered.
FOR EXAMPLE
, if installing for a 60” table top, slide the
C channel tube so as to expose one additional hole left-
of-center, and one additional hole right-of-center, to
reveal a total of three holes. The original exposed hole
must remain in the center, with an equal number of
newly-exposed holes to the right and left.
*If the center hole does not remain in the center
position, step 6 will not work!
5
ALIGN BASE TO TABLE TOP
FOR THIS STEP
THE MACHINE
screws for attaching the top to
the base are located in a separate bag from the screws
used to assemble the base. First, loosely attach the eight
(8) 5mm x 60mm machine screws to attach the crossbars
to that table top. Then, loosely attach the six (6) 5mm
x 20mm machine screws to attach the support arms to
the table. Finally, go back and tighten all 14 screws.
6
AFFIX BASE TO TABLE TOP
8x
FOR THIS STEP
not provided
the set screws are located
between the crossbars.
the middle hole
on the c channel
extensions
should remain
centered as you
adjust the legs.
6x
Marker/pen to mark center hole
(not provided)
base screws
30” x 48”
1
30” x 60”
3
30” x 72”
7
30” x 83”
9
TABLE TOP SIZE
# OF HOLES EXPOSED
IN EXTENSION BARS
