4
ASSEMBLY INSTRUCTIONS
CLEAR
a good-sized area to lay out all
components and assemble the desk. Lay the table top
down on the floor, insert nut side facing up. If not on
carpet, we recommend placing a soft blanket down first
in order to protect the table top surface. Make sure the
entire area is clear of any loose screws or debris, to avoid
scratching the laminated surface. Alternatively, this can
all be done on top of another table rather than on the
floor. Be careful not to slide the table top while upside-
down, to protect the laminate.
THE OMEGA
base is designed to work with any table
top, though assembly is easiest when using a genuine
OMEGA table top. OMEGA table tops include threaded
insert nuts that remove any confusion as to where
to drill, the bit size to use, or how deep to drill. These
recessed nuts also extend the life of the product, by
preventing degradation of the wood fibers from over-
tightening and from removing and reinstalling wood
screws too many times.
1
SET THE TABLE TOP
FOR THIS STEP
USING
the provided Allen key, attach the feet to
each lifting leg using four (4) 20mm (0.8”) round-head
machine screws for each leg. Note the position of the
feet relative to each leg’s motor housing (see diagram).
2
ATTACH THE FEET TO THE LEGS
FOR THIS STEP
CAUTION!
MOTORS ARE FACING
EACH OTHER
8x
2x
2x
feet
legs
