16
MANUAL RESET
CONTAINER- AND SHELF-STOP POSITIONS
IF THE
actual desktop position no longer corresponds to the height displayed, you can reset the lowest desktop
position to the minimum height.
PRESS
and hold the desktop down key until the desktop has reached the lowest
position (programmed desktop position).
PRESS
and hold the desktop down key again. After about 5 seconds, the desktop
will slowly move further down until it reaches the absolute lowest desktop position
possible (25 inches).
RELEASE
the desktop down key. The electric height-adjustable desk can again be
used normally.
NOTE:
The Container- and Shelf Stop Positions feature is not enabled during reset. Ensure that the area below the
desk is completely clear before performing a reset.
THESE TWO
features can be used to limit the movement area of the desktop (e.g. if a tall trash can is placed
underneath the desktop). A container stop position can be defined in the lower half of the movement area, a shelf
stop position in the upper half. If a container stop position is set, this position will be the lower limit position. If a
shelf stop position is set, this position will be the new upper limit position.
MOVE
the desktop to a position where the container stop or shelf stop position shall
be stored.
PRESS
S for 10 seconds. The Control Unit will click twice when the container stop
position is stored.
TO STORE A CONTAINER STOP / SHELF STOP POSITION:
MOVE
the desktop to any position in the lower half to deactivate the container stop.
Move the desktop to any position in the upper half to deactivate the shelf stop.
PRESS S
for 10 seconds. The Control Unit will click once when the container or shelf
stop position is deactivated.
TO DEACTIVATE THE CONTAINER STOP / SHELF STOP POSITION:
