5
ATTACH
the crossbars to both sides of each
motor housing using the twelve (12) 1” flat-
head machine screws provided. Take care to align the
holes properly so that the screws go in straight. Note:
only two of the three holes need to be used.
3
ATTACH CROSSBARS TO LEGS
FOR THIS STEP
ATTACH
the two support arms to the base,
using four of the eight (8)
⅝
” hex-head machine screws
provided. If your base is painted black, use the four (4)
black screws provided. If painted silver, use the four (4)
stainless steel screws provided. Insert the screws all the
way but
do
not
tighten them down at this point.
Make
sure the “lip” of each support arm is facing out from the
base. Note that the base is a cantilevered “C-Leg” design.
Of the four holes on the top support arm, use only the
two holes indicated in the diagram.
4
ATTACH TOP SUPPORT ARMS
FOR THIS STEP
although there are three
holes, only two need to be
used for proper installation.
OR
12x
4x
2x
4x
2x
make sure to align the three
holes of each cross bar to the
three holes of each leg
make sure to align the two
holes of each support arm to
the two holes of the leg
