17
TROUBLESHOOTING
IF THE
table cannot be raised or lowered, check the cable connection between the control unit and the motor units
(leg system), the handset and the control unit, as well as between the control unit and the power outlet.
IF THE
table still does not respond, the control unit may have triggered the overheating protection or the
intermittency protection. Please wait for at least nine minutes and try again before proceeding with other measures.
IF THE
control unit has been replaced - or unplugged for a substantial period of time - it must first be reset before
it can be used:
1.
LOWER
the table to its lowest position by holding the “Down” button on the handset.
2.
PRESS
the “Down” button on the handset again and hold it down until the table first
moves fractions of an inch downwards and then fractions of an inch back up again. The
control unit has now registered the lowest elevation and is ready to use.
3.
SHOULD
the table still not work as intended after taking these measures, please
contact the iMovR Customer Care Department for assistance.
THE OMEGA Keyboard Platform can be set to one of two height positions. By default, the bar assembly arrives set
to the lower position. You can adjust the bar assembly higher by removing the two hex screws from both ends of
the pivot bar, and reattaching the bar by inserting those same hex screws through the upper set of holes on the
bracket.
To adjust the Omega Keyboard Platform, simply loosen the central clamp by twisting the rubberized knob
counterclockwise. Then push down on the rear end of the platform for a steeper angle or push up from the bottom
of the platform for a shallower angle. Once you have the platform set to the desired position, secure it in place by
tightening the rubberized knob by twisting it clockwise.
Depending on the depth and shape of your keyboard you may want to adjust the rubber bumpers forward or back.
To do this, simply loosen the rubber bumper, slide it to the desired location, and retighten.
USING THE OMEGA KEYBOARD
PLATFORM
