imagistics im4720, Operator'S Manual

Page: 43 / 237

2-21
7. Auxiliary Functions
Gettin
g
to
Kn
o
w
Y
o
ur
M
a
ch
ine
Cha
p
te
r 2
The Interrupt function allows you to interrupt a
current job and run a different one. Pressing the
Interrupt key once sets the machine into the
Interrupt mode.
Pressing the Interrupt key again lets the machine
leave the Interrupt mode, returning to the previous
settings.
NOTES
• To cancel an Interrupt cycle, you need to press
the Interrupt key.
• Neither the Panel Reset key nor Auto Panel
Reset function is effective for canceling an
Interrupt cycle. If the optional Printer
Controller is mounted, however, Auto Panel
Reset can cancel one.
Useful Tips
• Pressing the Interrupt key sets the machine into
the initial mode, except for the finishing
function which is Non-Sort.
• Programming functions, such as Job and Zoom
Memory Input, are not enabled in the Interrupt
mode. Cover, Page Insertion, OHP
Interleaving, and Job Recall cannot be set in
the Interrupt mode, either.
By pressing the Mode Check key on the control
panel, you can either check for or change the
current settings.
• When you touch [Exit] after having checked the
currently set functions, the Basic screen
reappears.
• To change a certain function, touch the
corresponding key and then make the necessary
change.
If an access number has been programmed, it
allows only particular persons to use the machine
or a supervisor to keep track of the number of
copies made by a particular department.
NOTES
• If an access number has been programmed, a
copy cycle can be initiated only after the access
number has been input to the machine.
<“ Access #” Prompt Screen>
• Before you can use this function, you must first
turn “ ON” the “ Copy Track” function of the
Administrator Mode available from Utility
Mode.
☞
p. 5-19
Entering the Access Number
From the 10-Key Pad, enter the 4-digit
access number or 1-to-4-digit account
number, and press the Access key.
NOTE
To correct the 4-digit access number entered,
first press the Clear key, then enter the new
number.
When the initial screen reappears, you can
now start the copy cycle.
When the copy cycle is completed, press the
Access key again.
Interrupt
Mode Check
4003P140CA
<“Access#” Prompt Screen>
Access Number
4003P141CA
1
1 2 3
4 5 6
7 8 9
0 C
1134P438DA
2
3
Chapter2.fm Page 21 Tuesday, May 27, 2003 1:37 PM