Ikegami HDL-F3000, Operation Manual

Page: 51 / 70

5.5.1 Hierarchical Structure of the Engineer Menus
*** ENGINEER PAGE1 ***
MAIN MENU SUB MENU 1 SUB MENU 2 SELECT DEFAULT FUNCTION
NEXT PAGE Transitions to the PAGE2 of the engineer menu.
CAL OFF, 100%,
200% OFF Outputs the test signal.
The test signal is for checking the signal, and does not
show the accurate video level.
ECC CTRL CN OUT, IN OUT Selects whether the ECC terminal of the CTRL terminal
is used for input or output.
SMOOTH KNEE
SETUP QUIT Transitions from the sub menu to the main menu.
SMOOTH KNEE OFF, TYPE1,
TYPE2, TYPE3 TYPE1 Selects the type of SMOOTH KNEE.
TEST PULSE ON,OFF OFF Turns ON/OFF the test pulse for setting SMOOTH
KNEE.
POINT1 Sets the curve of SMOOTH KNEE.
Since there are three curve points, set each of them to
determine the whole curve.
You can set each of the curves: TYPE1, TYPE2, and
TYPE3.
SLOPE1
POINT2
SLOPE2
POINT3
SLOPE3
LOAD INT Restores the factory default data.
HI-LIGHT DTL
SET UP HI-LIGHT DTL ON, OFF OFF Turns ON/OFF the highlight DTL.
GAIN 0 to +100 Sets the GAIN of highlight DTL. Setting a larger value
will increase the edges to be added to high-brightness
parts.
LIMIT -100 to +100 Sets the clip point of highlight DTL edges.
Limits the amplitude of edges.
FINE DTL 0 to 8 8 Sets the level of FINE DTL. FINE DTL increases the
edges to be added to a subject with low contrast;
conversely, it decreases the ones to be added to a
subject with high contrast.
ND FILE ON,OFF ON Offsets the color temperature for each ND filter when set
to ON. This corrects the white balance deviation caused
by using the ND filter. No offset is triggered when it is set
to OFF.
DNR SETUP QUIT Returns to the previous screen.
DNR FUNCTION ENABLE,
DISABLE ENABLE Sets whether or not to execute digital noise reduction.
3D DNR ON, OFF ON Selects the mode in which 3D DNR is not used.
ATW SETUP QUIT Returns to the previous screen.
ATW DAY MODE NORMAL,
CUSTOM NORMAL Sets the operating range in DAY MODE.
NORMAL is a standard operating range. To change the
operating range, use CUSTOM mode.
The variable range is adjusted at C.TEMP SETTING
RED/C.TEMP SETTING BLUE/ATW REFERENCE.
ATW NIGHT MODE NORMAL,
CUSTOM NORMAL Sets the operating range in NIGHT MODE.
NORMAL is a standard operating range. To change the
operating range, use CUSTOM mode.
The variable range is adjusted at C.TEMP SETTING
RED/C.TEMP SETTING BLUE/ATW REFERENCE.
ATW SPEED 1 to 10 2 Adjusts the pull-in speed of ATW.
Setting 10 will reduce the pull-in speed.
START UP TIME 0FF, 1 to 5 OFF Adjusts the time before the ATW is activated.
Setting 5 will lengthen the time before the activation
starts.
C.TEMP SETTING
RED QUIT Returns to the previous screen.
RED LIMIT AUTO SET ON, OFF OFF Establishes the mode that can set the operating range
for the side with low color temperature.
RED LIMIT CONTROL -100 to +100 0 Sets the operating range for the side with low color
temperature.
RED LIMIT INIT ON, OFF OFF Restores the default value.
5-25 5. OPERATION