This document is property of NIIGATA POWER SYSTEMS CO., LTD. It must be neither reproduced nor communicated nor published without permission.
SECTION
4
- DISASSEMBLY AND REASSEMBLY
4.2 PISTON AND CONNECTING ROD
4-2-06
- If it is necessary to install new rod cap bolts, (either because of damage
or scheduled maintenance), the new bolts should first be installed and
torqued in the rod assembly without the bearings installed. Coat the
threads with Molykote or similar lubricant, tighten to the specified value
minus 10 degrees, loosen and repeat the procedure one more time. Then
install the cap with the new bolts, and tighten to the final torque spec
shown in Section 3.3. Stamp the bolts with a mark aligning with the mark on
the rod cap and also stamp with the cylinder number and bolt location
(position 1.4). Finally install the bearings and tighten to the mark.
Summary of Contents for NIIGATA MG(L)26HLX
