8BMenu
46BMain menu "Master Setup"
9-8
9.7
Main menu "Master Setup"
Setting master operating modes
Menu tree
Function
Master Setup
AS-i Master 1
Master Setup AS-i master 1
Master Setup
AS-i Master 1
Config
all
AS-i Master 1: Config all (password level 1
required)
Prerequisites:
- Operating mode = projecting
- No slave with the address 0 on the bus
> Safety query: "Are you sure?"
►
After [
OK
]:
> The
controllere checks all connected
slaves (only on this master) and enters
them as "projected" in its table.
> The operating mode stays "projecting"
Master Setup
AS-i Master 1
Operation
Mode
AS-i Master 1: operating mode (password
level 1 required)
→
page 10-2
> Display of the current setting
Master Setup
AS-i Master 1
Operation
Mode
Protect.
Mode
Operating mode "protected":
> LED
[
PROJ
] goes out.
> Changes to the slaves are detected
(LED [
CONF/PF
] lights). Slaves with a
different projected profile are not acti-
vated.
Master Setup
AS-i Master 1
Operation
Mode
Config. Mode
Operating mode "projecting":
> LED
[
PROJ
] lights.
> Changes to the slaves are detected
(LED [
CONF/PF
] lights). All connected
slaves are active.
Master Setup
AS-i Master 1
Autoaddr.
Mode
AS-i Master 1: mode "automatic address-
ing" (password level 1 required)
> Display of the current setting
►
Scroll between ON and OFF with
[
▲
] / [
▼
]
►
Adopt with [
OK
].
•
Automatic addressing ON:
Permits the replaced slave to be as-
signed the address of the old slave in
the protected mode (default)
•
Automatic addressing OFF:
The replaced slave must be manually
set to the right address.
