![background image](http://html1.mh-extra.com/html/ifm/ecomat-300-ac1307/ecomat-300-ac1307_basic-device-manual_620663186.webp)
15BError messages
103BProcess error: error codes E10...E30 (AS-i system)
16-6
Error message
Cause(s)
Solution
E27
Normal operation of the master not ac-
tive
The master reports that it is not in the
"Normal operating mode".
Possible causes:
1. The master detects an AS-i voltage
smaller than 22V and therefore
changes into the "Offline Mode".
2. The master has received a request
from the operating system to pass
into the "Offline Mode".
3. The master has found a transfer
error in the communication with the
operating system.
Other causes which can lead to the
error message directly after the device
has been switched on:
4. Initialisation of the master after
switching on the device was not
successful.
5. The master has not yet received the
projection nor the projected pa-
rameters from the operating system.
6. The master has not yet been started
by the operating system.
On 1:
►
Check the AS-i voltage supply on
the master and replace it – if neces-
sary
On 2:
►
Check AS-i voltage supply on the
master and replace it – if necessary
On 3:
►
Switch the PLC off and on again
►
Replace the controllere and project
again
On 4:
►
Switch the PLC off and on again
►
Replace the controllere and project
again
On 5:
►
Wait.
►
If too long:
→
4.
On 6:
►
Wait.
►
If too long:
→
5.
E28
Safety slave triggered on channel 1.
►
Error message not active at present
E29
Safety slave triggered on channel 2.
►
Error message not active at present
E30
Safety slave triggered.
The master has detected a "safety
slave" on the AS-i bus and detects that
the inputs of the slave are constantly
switched to LOW for a period of > 64
ms.
►
Check slave
►
Remove the cause of the error