EN
6 - USE AND OPERATION
SIR 52 MS52 P/F
6 - Pag. 22 / 30
31 Press
key
to close the truck-bar pusher locking device; LED of sensor S4 has to be
on. Otherwise, open locking device again, longitudinally move the bar pusher of some
millimetres and close locking device again.
32 Press
key
to open the guides.
33 Press
key
to rotate the clamp arm towards the drum.
34 Press
key
to close the guides.
35 Press
key
to open the truck-bar pusher locking device.
36 Press
key
to bring the remnant into the lathe collet.
37 Press
key
to make the clamp arm rotate outside the drum.
38 Give the lathe the order to make one spindle station rotate and stop it at zero point. Press
key
and repeat from step 15 to step 37.
39 Repeat step 38 until all bar pushers are replaced.
40 Remove all bars left from the magazine.
41 Prepare the new bars (paragraph 6.5.).
42 Load bars (paragraph 6.6.).
43 Adjust magazine (paragraph 5.1. and 5.2.).
44 Bring magazine control selector switch S 106 to position "1".
45 Press
key
.
Summary of Contents for SIR52 MS52 F
